Pairing LEDs
Hold the deadman switch to fuel. The LED slow-blinks in one color only (green, yellow, or red) based on battery level.
Release the switch to stop fueling immediately.
Pairing only works when the truck has been powered on less than 5 minutes and the handle is held very close to the receiver box (about 1 meter or closer).
1. Make sure the truck is on (less than 5 minutes).
2. Hold the handle close to the receiver box.
3. Tap the deadman 5 or more times rapidly.
4. When the truck responds, the LED slowly fades between green and yellow.
Press and hold the deadman switch for about 5 seconds. The LED turns solid green to show the handle and truck agreed on pairing.
After the solid green light, choose how this handle is stored on the truck:
• 2 quick taps – ADD this handle to the truck
• 5 or more quick taps – REPLACE the oldest stored handle
When pairing is complete, the LED quickly alternates between red and yellow, then returns to normal.
If the handle is still close to its previous truck, use this override sequence before pairing to a new truck:
1. Tap 5 times rapidly
2. Pause for 1–2 seconds
3. Tap 5 times rapidly again
Then follow the normal pairing steps.
Exact sequence:
• Tap exactly 5 times rapidly
• Pause for at least 2 seconds
• Tap exactly 5 times rapidly
• Pause for at least 2 seconds
• Tap exactly 5 times rapidly
This clears all stored trucks and returns the handle to factory state.
Each truck can remember up to two handles. If a third handle is paired, the oldest handle is replaced.